We provide, service and maintenance contacts, training for operators and programming staff plus calibration and condition ( machine health check ) reporting. .

SERVICE CONTRACTS / SCHEDULE
MACHINING CENTRE / LATHE

* INTERIM SERVICE ( Typical )

* Hydraulics/Lubrication:
Check system operation/leaks
Check system pressure & reset if required
Check gauges
Check hydraulic assemblies operation/leaks
Check slideway lube system operation/leaks
Check slideways, linear guides, b/screws for lube

* Pneumatics:
Check System Operation/Leaks
Check main supply pressure & reset if required
Check gauges
Check Air Filters
Check oil mist if required

* Coolant:
Check system operation/leaks
Check/clean filters

* Electric's/Control:
Check/clean all fans
Check Sensors/Limits, optimise CNC Parameters
Check Servo Motors/Response (adjust as required)
Check Spindle Motors/Response (adjust as required)
Check and set Servo Trailing Errors.
Check/clean all filters
Check cables and connectors
Check/clean work/operator condition lights
Check/clean heat exchanger
Check screen and operator controls.
Check modes of operation.

* Mechanics:
Check Spindle/Chucking operation.
Check spindle operation/noise
Check spindle/c axis repeatability (if applicable)
Check axis/ballscrew operation/noise
Check/adjust axis backlash
Check adjust turret centre line position (if applicable)
Check turret height (if applicable)
Check ATC operation/noise (if applicable)
Check magazine operation/noise & chain tension (if applicable)
Check pallet change/robot operation/noise (if applicable)
Check tool clamp force (if applicable).
Check linear guide pad wipers.

* General:
Check overall machine operation
Check safety interlock operation
Check guards/cover/windows
Check/clean under axis covers and slideway
gulleys
Check operation of tool measure systems(if applicable)
Check/adjust tool measure systems calibration (if applicable)
Reset maintenance check screen (if it applies).

* FULL SERVICE

Hydraulics:
As Interim service
Check, clean and/or replace filters as required
Replace main hydraulic oil, clean tank
Replace slideway oil, clean tank
Replace spindle lube/chiller fluid, clean tank

Pneumatics:
As interim service.

Coolant:
As interim service
Check, clean and/or replace filters as required
Replace coolant, clean tank if required by customer

Electrics:
Check memory and replace back-up batteries.
Check and record cabinet working temperature and ambient temperature.
As interim service

Mechanics:
As interim service
Check and report machine level/alignments if required
Test cut on lathes (check for taper cutting).

General: As interim service.
Other work (subject to discussion)
Laser Calibration
Ball Bar, Full Geometry Checks
Machine Condition Reports

· Customer to be consulted before adjusting alignments, calibration and carrying out test cut, etc.
· Discuss service findings with customer.